Asante-technologies 7000 Bedienungsanleitung

FriendlyNET 7000 SeriesGigabit Ethernet Switches User’s Manual

Introduction Page 1-4 ❑ Complies with IEEE 802.3 Ethernet, IEEE 802.3u Fast Ethernet, IEEE 802.3z Gigabit Ethernet, and IEEE 802.3x flow control (in f

Switching Technology Page 1-5 To ensure network reliability, a switch monitors each of its ports for signal quality. The switch automatically disconn

Introduction Page 1-6

Page 2-1 2Installation This chapter describes the components and explains how to install, mount, and apply power to your FriendlyNET 7000 Series Giga

Installation Page 2-2 Components This section describes the front- and back-panel layouts of the FS7108 and FS7016 Switches.The only control on the f

Expansion Modules Page 2-3 FS7016 Base Unit The front panel of the FS7016 contains sixteen 10/100Mbps ports, two expansion slots, one uplink switch b

InstallationPage 2-4To install the Gigabit SX XP Module: 1 Power down the unit.2 Remove the metal cover from the front of an empty expan-sion slot (lo

100 FX MII ModulePage 2-5◆ Note: Each 10/100 expansion module provides 8 ports which are numbered 1 through 8. If the module is installed in Option S

InstallationPage 2-62 Align the bottom of the MII module with the rails on the inside of the MII slot.3 Slide the MII module into the MII slot until i

Mounting ConfigurationsPage 2-7Desktop MountingTo mount the Switch on a desktop or shelf:1 Attach the four rubber feet (supplied) to the bottom of eac

Copyright NoticeTrademarks Asanté Technologies and FriendlyNET are trademarks of Asanté Technologies, Inc. Ethernet is a registered trademark of the

InstallationPage 2-82 Mount the Switch in the equipment rack by screwing the mounting brackets to the equipment rack. See Figure 2-11.Figure 2-11 Mo

Connecting Network DevicesPage 2-9Connecting Network DevicesThis section describes how to connect computers, hubs and switches to the FS7000 Switch, a

InstallationPage 2-10Connecting a Hub or a Switch to the Asanté Switch❑ Use a two-pair Category 5 UTP straight-through cable with RJ-45 connectors ❑ C

Voltage RequirementsPage 2-11Cascading Multiple FS7000 SwitchesMultiple FriendlyNET 7000 Series Switches can be connected together (called cascading).

InstallationPage 2-12

Page 3-13LED IndicatorsThis chapter explains how to interpret the front-panel LED indicators on FriendlyNET 7000 Series Gigabit Switches. There are no

LED IndicatorsPage 3-2Figure 3-2 FS7000 LEDsUnits with a Gigabit SX XP module installed have the following additional LEDs for monitoring the status

LED Indicators for Port ConnectionsPage 3-3LED Indicators for Port ConnectionsAll FS7000 Series Switches include 100/10Mbps, Full/Half Duplex and Link

LED IndicatorsPage 3-4Link/Data LEDThe green Link/Data LED indicates whether a device is detected on the other end of the port, and whether activity i

LED Indicators on Gigabit SX ModulePage 3-5Full Duplex/Collision LEDThe Gigabit module’s green or amber Full Duplex/Collision LED indicates port opera

Page i Table of Contents About This Manual ...iii Chapter Contents ...

LED IndicatorsPage 3-6

Page A-1ATroubleshootingTable A-1 describes how to troubleshoot problems with your network and/or the Switch by monitoring the Switch’s LEDs. Table A-

Page A-2

Page B-1BSpecificationsFS7000 Series SpecificationsStandards IEEE 802.3 10Base-T Ethernet IEEE 802.3u 100Base-TX Fast Ethernet IEEE 802.3z 1000Base-XIEE

Page B-2FS7000 Series Physical and Environmental SpecificationsAC Inputs 100–240 volts AC, 50/60 Hz (internal universal power supply)Power Consumption1

Page B-3Gigabit SX XP Module SpecificationsStandards IEEE 802.3z 1000Base-XIEEE 802.3x flow controlData Transfer RateGigabit Ethernet1000MbpsNetwork Cab

Page B-4

Page C-1CTechnical SupportContacting Technical SupportTo contact Asanté Technical Support:Telephone (800) 622-7464Fax (801) 566-3787Fax-Back (800) 741

Page C-2

ASANTÉ TECHNOLOGIES, INC., 821 FOX LANE, SAN JOSE, CA 95131PHONE: 800.622.7464 • FAX: 801.566.3787 • e-mail address: [email protected] •World Wide Web

Page ii Cabling Requirements ...2-8Connecting Network Devices ...2-9Connecting a Computer to

Page iii About This Manual This manual describes the complete line of FriendlyNET 7000 Series Gigabit Switches. The manual often focuses on two model

Page iv Chapter Contents This manual is divided into the following chapters and appendices: ❑ Chapter 1, “Introduction,” provides an overview of Frie

Page 1-1 1Introduction This chapter introduces Asanté FriendlyNET 7000 Series Gigabit Switches and provides an overview of switching technology. Intr

Introduction Page 1-2 A Media Independent Interface (MII) slot is built in to the back panel of all 7000 Series Switches. An Asanté 100 FX MII module

Introducing the FriendlyNET 7000 Series Page 1-3 Features The FriendlyNET 7000 Series Gigabit Switch has the following features: ❑ Compact size — des